Table of Contents
Advertisement
CHAPTER 3.
E
Market
29L-FG5RU
Service Manual
29L-FG5RU
TV
ADJUSTMENT PRECAUTIONS
[1] ADJUSTMENT PRECAUTIONS
This model's setting are adjusted in two di erent ways: through the I2C bus control and in the
conventional analog manner. The adjustments via the I2C bus control include preset-only items and
variable data.
1. Setting the service mode by the microprocessor.
(1). Press and hold the local key "VOL DOWN" & "CH UP" when power on the main switch,
TV will enter into SERVICE MODE. (The initial values of EEPROM are automatically
preset when new EEPROM is used.)
(2). Press the CH DOWN / UP key on the remote controller to get ready to select the mode
one by one.
(3). Press the CH DOWN / UP key on the remote controller to select the modes reversibly
one by one.
(4). Using the VOLUME UP/ DOWN key on the remote controller, the data can be modi ed.
(5). When press the local key "VOL DOWN" & "CH UP" at the same time, it will be released
from the service mode.
2. Factory Presetting.
(1). After enter into the SERVICE MODE, at "INIT EEPROM" service item (which is under
"CHECK MODE" section) press remote control
are automatically preset.
(2). The initial data are preset as listed in page 4 to 14.
(3). Make sure whether the data need to modify or not (Initial data).
Note:
Once the chassis has been assembly together and in ready condition, please make
sure it's go through initialize process (see sect 2-(1) above).
Precaution: If haven't done this initialization, malfunction might be happen.
ADJUSTMENT PRECAUTIONS
3 – 1
ler key of code "ED", the initial values
Advertisement
Table of Contents
