Application Examples - Ubiquiti PBE-M5-300-US Quick Start Manual

LAN and DHCP server.
Reset Button
To reset to factory defaults, press and hold the Reset button for more than 10
seconds while the device is powered on. Alternatively, the device may be reset
remotely via a Reset button located on the bottom of the PoE adapter.
Release Button
After you assemble the device, check the Release button; it should be fully
engaged in the Release Button Slot of the Rear Housing. This ensures that the
Antenna Feed is locked into place. If you need to remove the Antenna Feed, you
must depress the Release button first.
Signal LEDs
In airOS®, you can modify the threshold values for the wireless signal strength
LEDs on the Advanced tab under Signal LED Thresholds. The default values are
shown below:
Ethernet LED
The Ethernet LED will light steady green when an active Ethernet connection is
made and flash when there is activity.
Power LED
The Power LED will light green when the device is connected to a power source.

Application Examples

The PowerBeam mounted outdoors with the Reflector installed provides directional
outdoor coverage (gain is reflector-dependent).
PBE-M5-300 Quick Start Guide