Table of Contents
Advertisement
1. INITIAL SETUP
1.1
Kit Contents
The CRD5378 reference design kit includes:
• CRD5378 reference design board
• USB cable (A to mini-B)
• Software download information card
The following are required to operate CRD5378, and are not included:
• Bipolar power supply with clip lead outputs (+/- 3.3 V @ 100 mA)
• PC running Windows 2000™ or Windows XP
• Internet access to download the evaluation software
1.2
Hardware Setup
To set up the CRD5378 reference design hardware:
• Verify all jumpers are in the default settings (see next section).
• With power off, connect the CRD5378 power inputs to the power supply outputs.
J26 pin 17 = -3.3 V
J26 pin 19 = +3.3 V
J26 pin 20 = 0 V
• Connect the USB cable between the CRD5378 USB connector and the PC USB port.
• Proceed to the Software Setup section to install the evaluation software and USB driver.
6
®
with an available USB port
CRD5378
DS639RD2
Advertisement
Table of Contents
Need help?
Do you have a question about the CRD5378 and is the answer not in the manual?