General; Tools Required For Installation (Not Supplied); Accessories Supplied With Unit; Optional Copper Tubing Kit - Argo AE2MI56AH Installation Instructions Manual

1. General

This booklet briefly outlines where and how to install
the air conditioning system. Please read over the entire
set of instructions for the indoor and outdoor units and
make sure all accessory parts listed are with the sys-
tem before beginning.

1-1. Tools Required for Installation (not supplied)

1. Standard screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter's level

1-2. Accessories Supplied with Unit

Table 1
Parts Figure Q'ty
Remote
control unit
AAA alkaline
battery

1-3. Optional Copper Tubing Kit

Copper tubing for connecting the outdoor unit to the
indoor unit is available in kits which contain the narrow
and wide tubing, fittings and insulation. Consult your
nearest sales outlet or A/C workshop.

1-4. Type of Copper Tube and Insulation Material

If you wish to purchase these materials separately from
a local source, you will need:
1. Deoxidized annealed copper tube for refrigerant
tubing as detailed in Table 2.
Cut each tube to the appropriate lengths +30 cm to
40 cm to dampen vibration between units.
Table 2
Narrow Tube
Model
Outer Dia.
AWMI28AHL 6.35 mm
AWMI36AHL 6.35 mm
AWMI50AHL 6.35 mm
AWMI70AHL 6.35 mm
2. Foamed polyethylene insulation for the specified
copper tubes as required to precise length of tub-
ing. Wall thickness of the insulation should be not
less than 8 mm.
Parts Figure
Remote
1
control holder
Truss-
Tapping
2 head
screw
4 × 16 mm
screw
3.
Wide Tube
Thickness Outer Dia.
0.8 mm 9.52 mm
0.8 mm 9.52 mm
0.8 mm 9.52 mm
0.8 mm 12.7 mm
2
6. Sabre saw or key hole saw
7. Hacksaw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)
Q'ty Parts
Truss-
Tapping
1 head
screw
screw
2
Use insulated copper wire for field wiring. Wire size
varies with the total length of wiring. Refer to 3-6.
Wiring Instructions for details.
Check local electrical codes
CAUTION
and regulations before
obtaining wire. Also, check
any specified instructions or
limitations.
Thickness
0.8 mm
0.8 mm
0.8 mm
0.8 mm
Figure Q'ty
8
4 × 30 mm