If the hot water system has not been used for such a period, before using the washer, turn on all the hot water faucets and let the water flow from each faucet for several minutes.
Page 3
3. Do not install or store this appliance where it will be exposed to the weather. 4. Install and level washer on a floor that can support Surfac e Co o king the weight.
• The washer will pause briefly throughout each cycle. These pauses are normal. • This washer is designed so that it will not agitate or spin when the lid is open. It will, however, fill with the lid open so water is available for pretreating stains or diluting fabric softener.
• Check fuse or reset circuit breaker. • Close lid and restart the washer. For your safety, washer will not agitate or spin unless lid is closed. • This may be a pause in the cycle. Wait briefly and it may start.
Super Note: Items must circulate freely for best results. STEP Select Wash/Rinse Temperature Your washer gives you a choice of hot, warm or cold water for washing and cold or warm water (select models) for rinsing. WASH/RINSE LOAD TYPE TEMPS...
STEP Pull Control Dial Out to Start You may stop the washer at any time by simply pushing the control dial in. Therefore it is possible to obtain a non-agitated soak or to shorten, skip or repeat any part of a cycle.
Super Note: Items must circulate freely for best results. STEP Select Wash/Rinse Temperature Your washer gives you a choice of hot, warm or cold water for washing and cold or warm water (select models) for rinsing. WASH/RINSE LOAD TYPE TEMPS...
Page 9
Delicates STEP Pull Control Dial Out to Start You may stop the washer at any time by simply pushing the control dial in. Therefore it is possible to obtain a non-agitated soak or to shorten, skip or repeat any part of a cycle. The control dial must be pushed in (off position) when you change the setting.
Safety Spin If for any reason you open the washer lid when the washer is in a spin or extract period, the operation will immediately stop. This is for your personal safety. If your washer does not stop, call your service technician immediately.
Not es 6. Do not lay heavy or sharp objects on top of your washer. 7. The top of the washer should not be used for removing stains from garments. Some stain removers, such as rust remover, will mar the finish.
Service Information For service, please contact the Maytag dealer from whom you purchased this appliance. For service in Australia, please contact Maytag Appliances on 1 300 858 575. ABN 88 086 686 884 Manufacturer: MAYTAG APPLIANCES: 1 Dependability Square, Newton, IA 50208 U.S.A.
Need help?
Do you have a question about the Performa PAVT-5 and is the answer not in the manual?
Questions and answers