Advertisement
4
2
1 Ashtray. When you open the door, you have access to the ash-
tray, which is placed below the combustion chamber.
Attention! Be careful when you empty ashes from the stove.
There may be embers left for up to 24 hours after the stove
was last used.
2 Handle for shaking grate. The stove is equipped with a shaking
grate. When you activate the grate handle, the ashes from the
combustion chamber are emptied into the ashtray.
3 Regulation for primary air. Turn the air valve in order to open.
The primary air is used when lighting and refuelling the stove. It
should always be closed during continuous firing.
4 Regulation for combustion air. Push the button sideways. Left
position is closed and right position is open. The air is used for the
combustion and regulates the output of the stove.
The ashtray, shaking grate, and primary air should always be clo-
sed during continuous firing.
You should read this manual as well as the General Instructions for Installation before beginning the installation.
SCAN Andersen 4
3
1
Mounting of the convection
plates and the base
Place the stove carefully on the back and mount the
convection plates/base as shown on the sketch. The
screws and fittings are delivered together with the
convection plates/base.
Mounting of the soapstones
An instruction is delivered together with the soap-
stones.
Handle
Your stove is equipped with a loose handle, which is
practical if you have small children. Put the handle
into the hole and turn it to open the door. If you want
a firm handle, you can mount the long screw that
you will find in the service bag.
Advertisement
