Advertisement
Congratulations on your new SCAN Andersen-
stove!
You have chosen a product from one of Europe's leading manufacturers of wood-burning stoves. We are convin-
ced that your stove will be to your full satisfaction and give you many hours of pleasure if you follow the advice
and instructions of this manual.
Please read this manual as well as the General Instructions for Installation before beginning the installation.
Clean combustion
The SCAN Andersen 4 uses the "CB techni-
que" (Clean-Burn) to ensure an optimally clean
combustion. The extra combustion air is pre-
heated and led into the combustion chamber
close to the ceramic smoke deflector.
Ceramic smoke deflectors
Follow the sketches below for the dismounting
of the ceramic smoke deflectors. Remove the
log guard (a). Lift the lower smoke deflector
plate, pull out the pins of the lateral firebricks,
and remove the plate. The upper smoke
deflector plate can be removed in the same
way.
a
Building-in
If the stove is to be built in, you must block the
four holes in the bottom, as the stove will other-
wise draw in false air.
SCAN Andersen 4
Ceramic smoke deflectors
Mounting of the heat shields
You have to mount separate heat-shields
under the SCAN Andersen 4. Place the stove
carefully on the back and mount the heat-
shields as shown on the sketch.
Adjustment of the air
SCAN Andersen 4
Combustion air %
Primary air %
Fuel kg/h (beechwood
Wood / briquettes
max. 20% humidity)
100
0-25
1,8 kg
Advertisement
