Supply Lines - SCHUNK TANDEM KSP3 64 Assembly And Operating Manual

Assembly and connection

5.3.1 Supply lines

Hose-free direct connection
Connection Ø A [mm]
III - IV
Ø B [mm]
T [mm]
O-ring* [mm]
Connection Ø A [mm]
1-8
Ø B [mm]
T [mm]
O-ring* [mm]
22 04.00 | KSP3, KSP3-LH, KSP3-F | TANDEM Clamping Block | en | 1463318
The clamping force block has four air connections: I, II, III, IV.
Two connections for OPEN (I and III) and two connections for
CLOSE (II and IV).
The application determines which of the two air connections must
be opened for actuation:
• Connections I and II for operation without a base plate.
• Connections III and IV in the base for hose-free direct
connection to the machine table or on the base plate.
The threads for hose-free, direct connection are not designed for
pneumatic fittings.
Thread for pneumatic fitting (front):
KSP3, KSP3-LH, KSP3-F 64 and 100
KSP3, KSP3-LH, KSP3-F 140, 160, 200 and 250
KSP3, KSP3-LH, KSP3-F 315
64
3
5.3
0.6
Ø
3.5x1
*included in accessory kit and sealing kit
NOTE:
All four air connections come sealed on delivery of the clamping
force block. On the base side with set-screws (item 60) and on the
front with locking screws (item 23).
When using the air purge via connection 5, the two sound
absorbers (V) must be removed and replaced by set-screws (item
93).Accessory kit [/ 40]
Requirements for compressed air supply: compressed air,
compressed air quality according to ISO 8573-1: 7:4:4
Unconditioned compressed air contains dust and oil particles and
moisture, all of which can lead to malfunctions or premature wear
in the clamping force block. The oiler should be no more than 2
meters from the coupling point.
The clamping force block has two more base connections (6/7) for
direct lubrication through the machine table. These connections
come sealed on delivery with set-screws (item 62).
Size
100 140 160
4
8.8
1.0
Ø 6x1.5
4
8.8
1.0
Ø 6x1.5
M5
G 1/8"
G 1/4"
200 250 315
7
12.8
1.4
Ø 9x2
7
12.8
1.4
Ø 9X2