Installing Weather Plate And Gland Nuts - Electro-Voice MTS Installation Manual

18 en | Wiring and connections
4.4

Installing weather plate and gland nuts

A
2021-09 | V01 | F.01U.386.524
B
x1 x2
1. Remove (2) screws and the
weatherproof plate from the input cup.
Note the orientation of the plate since
the screw holes are not symmetrical.
PH2
x2
2. Remove the gland nut kit and (2)
terminal block connectors from inside
the input cup.
3. Install the gland nuts onto the plates.
If the loudspeaker only requires 1 cable,
use the gland nut plug on one of the
gland nuts.
4. Feed the cable(s) through the gland
nuts.
5. Connect each wire to the appropriate
point on the terminal block.
PH1
Installation manual
MTS High Output Point Source
Electro-Voice