Electro-Voice MTS Installation Manual page 29

MTS High Output Point Source
Correct
Install lateral support bars after the
loudspeakers are mounted to the frame sides
to ensure they are tight to the loudspeakers,
and that the frame is rigid between the side
mounting points.
Use M10 fasteners that penetrate the
loudspeaker element 30 - 45 mm (1.2 - 1.8
in). Use thread locker and appropriate torque
for the type of fastener used. Fastener torque
must not exceed 13.5 N*m (120 in*lbs). Only
use fasteners that are capable of supporting
the weight of the loudspeaker with a safety
factor appropriate for local laws and
regulations.
Electro-Voice
Incorrect
DO NOT use plates on each side of the array
without lateral support.
DO NOT use fasteners that are too long or
too short.
25mm
[1in]
Installation manual
Designing an MTS array | en
2021-09 | V01 | F.01U.386.524
29