Folding; Reclining Backrest; Using The Handle And The Hood; Footmuff - JANE MICRO-PRO2 Instructions Manual

D. FOLDING
Fold the hood. Close the foot cover.
and fasten them at the points found on the base of the carrycot.
Fold the ProFix adaptor inwards.
WARNING: This step must never be done with the baby insi-
!
de the carrycot. It is inevitable that sharp points and areas
where body parts could get trapped emerge during these
operations.
E. RECLINING BACKREST
The back of the carrycot can be reclined so the baby can enjoy more
of a sitting up position.
To raise it, pull the side strap upwards
far as it will go, slowly release it until it locks into place
is firmly locked into place.
To move it back to the lying down position, pull the central strap
The mechanism will unlock and you can gently release it back to the
lying down position 3d .
F. USING THE HANDLE AND THE HOOD
This carrycot is fitted with a central handle for carrying. The handle is
also used as a support for the hood.
The handle can be rotated to fold the hood. To rotate it, press the two
20
EN
2 2a
- Pull the folding straps
B
3a
. Once you have pulled it as
3b . Check that it
3c
buttons on the sides. When you release the buttons, the hood will be
locked into the nearest position.
If you are using it as a carry handle, make sure that the handle is in the
A
upright position and is properly locked in place.
The hood can be folded, unfolded and removed.
To fit the hood place both flaps around the handle and close the
zips. The skirt is attached to the carrycot by another zip. For
greater ventilation and to be able to see the child, the hood has
an extra section made of mosquito netting: you can access this
section by undoing the zip between the first and second sections
of the hood.
To remove the hood, follow the same steps in reverse.
!
WARNING: Do not place any weight on top of the hood.
G. FOOTMUFF
To settle your baby, undo the zip of the footmuff to the required level.
5a
To fully remove the footmuff, undo the zip completely.
H. ATTACHING THE CARRYCOT TO A JANÉ PUSHCHAIR
To attach the carrycot to a Jané chassis, position the carrycot so
that the child's head is facing away from the handlebar.
4a
.