Dometic BUTTNER MT iQ Solar Monitor III Installation And Operating Manual page 18

Using the solar monitor
9.7 Activating or deactivating the switching output manually
I
NOTE
The manually set state of the switching output remains valid only until the voltage or
time control settings apply.
1. Press and hold the
✔ "On" is displayed.
✔ The switching output is activated.
2. Press and hold the
✔ "Off" is displayed.
✔ The switching output is deactivated.
9.8 Resetting the solar charge counter
I
NOTE
Each solar charge counter value (Ah and kWh) can be reset separately.
1. Press the button to display the solar system information menu.
2. Press the button to switch through the solar system information menu until the total solar
charge generated in Ah is displayed.
3. Press and hold the
✔ "Set ----" is displayed.
✔ The solar charge counter (Ah) is reset.
4. Press the button to switch through the solar system information menu until the total solar
charge generated in (k)Wh is displayed.
5. Press and hold the
✔ "Set ----" is displayed.
✔ The solar charge counter (kWh) is reset.
6. Press and hold the
18
button for 3 seconds.
button for 3 seconds.
button for 3 seconds.
button for 3 seconds.
button for 3 seconds to quit the menu.
MT iQ Solar Monitor III
EN