Dometic BUTTNER MT iQ Solar Monitor III Installation And Operating Manual page 17

MT iQ Solar Monitor III
5. Press the button to save the setting.
✔ The settings menu is closed and the start screen appears.
9.6 Setting voltage controlled switching output
I
NOTE
The switching output can be set voltage controlled or time controlled. If activated, set-
ting the voltage control automatically deactivates the time control.
1. Press the button to open the solar system information menu.
2. Press the button to switch through the solar system information menu until the recent volt-
age (V) is displayed.
3. Press and hold the
✔ If the timer is activated, "--:-" is displayed.
5. Press the button to save the setting.
7. Press the button to save the setting.
✔ "LEd" is displayed.
8. Adjust the LED back light (chapter "Setting the LED back light" on page 16) or press the
button to save the settings.
✔ The settings menu is closed and the start screen appears.
EN
button for 3 seconds to open the settings menu.
✔ "Set on" flashes.
4. Press the
switch-on threshold.
Note: If the automatic switch-on is not to be used, set a high
switch-on threshold (e.g. 16 V).
✔ "Set off" flashes.
6. Press the
switch-off threshold.
Note: If the automatic switch-off is not to be used, set a low switch-
off threshold (e.g. 9 V).
button (minus) or the
button (minus) or the
Using the solar monitor
button (plus) to set the
button (plus) to set the
17