Dometic BUTTNER MT iQ Solar Monitor III Installation And Operating Manual page 16

Using the solar monitor
✔ The settings menu is closed and the start screen appears.
9.4 Deactivating the timer for time controlled switching output
I
NOTE
The switching output can be set voltage controlled or time controlled. If activated,
deactivating the timer automatically activates the voltage control.
1. Press the button to display time and date.
2. Press and hold the
✔ "Set" flashes.
3. Press the button until "Set On" flashes.
4. Press the button (minus) or the
5. Press the button to save each setting.
✔ "--:--" is displayed.
6. Press the button to save the setting.
✔ The timer is deactivated.
✔ "Set LEd" is displayed.
7. Adjust the LED back light (chapter "Setting the LED back light" on page 16) or press the
button to save the settings.
✔ The settings menu is closed and the start screen appears.
9.5 Setting the LED back light
I
NOTE
The LED back light can be adjusted in 10 % steps which are indicated by a bar graph.
1. Press the button to display time and date.
2. Press and hold the
✔ "Set" flashes.
3. Press the button until "Set LEd" is displayed.
4. Press the button (darker) or the
16
button for 3 seconds to open the settings menu.
button (plus) to set the minutes and the hours to "00".
button for 3 seconds to open the settings menu.
button (brighter) to adjust the LED back light.
MT iQ Solar Monitor III
EN