Honda FF500 Owner's Manual page 29

Tilling width adjustment
The tilling width is factory-set at the wide position. Remove the outer rotary to
narrow the tilling width.
• Equalize the space difference between the tilling width and the rear wheel
tread. Also equalize the space in the right and left sides.
• As the reverse-spinning outer rotary is removed to narrow the tilling width, the
tilling is only in the normal direction of rotation.
• Wear heavy gloves to protect your hands.
• Carry out the adjustment with the tiller on the level ground and the engine
stopped. Disconnect the spark plug cap to prevent an accidental start-up.
1. Set the front wheel ''For transportation'' (see page 25).
2. Remove or install the outer rotary. Refer to page 51 for removal, page 52 for
installation.
3. Set the front wheel at a condition other than ''For transportation'' , and ground
the rotary (see page 25).
4. Alter the rear wheel tread to adjust to the tilling width (see page 27).
26