Set Ip Address Filter; Set Https - HIKVISION DS-2TD2636B-15/P User Manual

Thermal & Optical Bi-spectrum Network Camera User Manual
Set Log Server
The log server should support syslog (RFC 3164) over TLS.
Steps
1. Check Enable Log Upload Server.
2. Input Log Server IP and Log Server Port.
3. Click Test to test the settings.
4. Install client certificate.
1) Click Create to create the certificate request. Fill in the required information in the pop-up
window.
2) Click Download to download the certificate request and submit it to the trusted certificate
authority for signature.
3) Install the signed certificate to the device.
5. Install the CA certificate to the device.

10.12.3 Set IP Address Filter

IP address filter is a tool for access control. You can enable the IP address filter to allow or forbid
the visits from the certain IP addresses.
IP address refers to IPv4.
Steps
1. Go to Configuration → System → Security → IP Address Filter.
2. Check Enable IP Address Filter.
3. Select the type of IP address filter.
Forbidden
Allowed
4. Edit the IP address filter list.
Add
Modify
Delete
5. Click Save.

10.12.4 Set HTTPS

HTTPS is a network protocol that enables encrypted transmission and identity authentication,
IP addresses in the list cannot access the device.
Only IP addresses in the list can access the device.
Add a new IP address to the list.
Modify the selected IP address in the list.
Delete the selected IP address in the list.
67