Mview / Web Interface; Figure 20 Mview Redirecting To Redundant Digital Gateway; Figure 21 Redundancy Error Shown In Mview By A Red Square - ABB LVS Digital Manual

With umc motor controller, interface manual profibus

Hide thumbs Also See for LVS Digital:

Table of Contents

R EDU NDA NCY

6.4 MView / Web Interface

In a dual redundant configuration, the MView is connected via the same Ethernet net-

work to both Primary and Backup Digital Gateway

If a changeover takes place, the current Primary will become the Backup (if still functioning) and

the Backup will become Primary Digital Gateway.

The MView is automatically redirected to the new Primary Digital Gateway (which was the

Backup Digital Gateway before) without user interaction.

While redirecting, the MView shows the following window: Prior to the re-direction the

background in MView changes to yellow to indicate that current Web Interface is connected

to the Backup Digital Gateway. Once it has re-directed to the new Primary Digital Gateway

the background returns to its usual color.

Below screenshots are showing such a change-over scenario:

Note:

If a change-over fails or in case any other redundancy error occurs that will be indi-

cated by red square in MView (see Fig26 above).

1 TG C90 80 04

MV I EW / WEB I NT ERFACE

Table of Contents