Korg Pitchclip 2 - Clip-On Tuner Manual

Parts of the Pitchclip 2

1. Power button
2. Battery cover
3. Clip
4. Display
5. LED meter
6. Note name

Installing the battery

(Fig.2)

Make sure to turn the power off before you replace the battery. Open the battery cover by sliding it off. Place the battery in the compartment with the "+" side facing up, and then replace the battery cover. When the battery runs low, the note name indicator will blink, and the LED meter will no longer operate smoothly. When this occurs, install a fresh battery as soon as possible.

Attaching the Pitchclip 2

Attach the Pitchclip 2 to the headstock of your guitar or bass. Adjust the display to the angle that provides the best visibility.

Do not open the Pitchclip 2 farther than 120 degrees. Applying excessive force will damage the unit.

Do not leave the Pitchclip 2 attached to your instrument for extended periods of time. Leaving the Pitchclip 2 attached for long periods of time may damage the finish of your instrument.

Tuning

(Fig.4, Fig.5)

1. Press the power button to turn on the power. Holding down the power button for longer than one second will vertically reverse the display (Fig.4). Use of this feature is determined by the physical placement of the Pitchclip 2.
2. Play a single note on your guitar or bass. The display will indicate the note name that is closest to the pitch that you played (C, C♯ ♯ ♯ ♯, d, d♯, E, F, F, G, G, A, A, b).
3. Tune your guitar or bass to make the center of the LED meter light up (Fig.5-b). The left side of the LED meter will light up if your instrument is flat (Fig.5-a), and the right side will light up if your instrument is sharp (Fig.5-c).
4. To turn off the power, press the power button. If approximately three minutes pass without the Pitchclip 2 detecting any sound, the power will turn off automatically (Auto power-off).

Specifications

Scale: 12-note equal temperament (A4=440Hz)
Detection range (sine wave): A0 (27.50Hz)—C8 (4186.0Hz)
Precision: +/-1 cent
Power supply: coin-type lithium battery (CR2032) x 1
Battery life: approximately 24 hours (continuous A4 input)
Dimensions(W x D x H): 52 x 24 x 34 mm / 2.05 x 0.94 x 1.34 inches
Weight: 17g / 0.60oz. (including battery)
Included items: Owner's manual, coin-type lithium battery (CR2032) x 1

* Specifications and appearance are subject to change without notice for improvement.