•
Never start the product if the product is leaking fuel.
Check regularly for leaks from the fuel cap and fuel
lines.
•
Always put the product on a flat surface and make
sure the cutting attachment cannot come in contact
with any object while you add fuel.
•
Take care when handling fuel. Bear in mind the risk
off fire, explosion and inhaling fumes.
•
Observe caution when handling fuel and make sure
there is adequate ventilation. Fuel and fuel fumes
are highly inflammable and can cause serious injury
when inhaled or allowed to come in contact with the
skin.
•
Mix and pour fuel outdoors, where there are no
sparks or flames.
•
Do not smoke or place hot objects near fuel.
•
Always stop the engine and let it cool off for a few
minutes before you refuel.
•
Open the fuel cap slowly so that any excess
pressure is released gently when you refuel.
•
Tighten the fuel cap carefully after you refueled.
•
Clean the area around the fuel cap. Contamination in
the tank can cause operating problems.
•
Always move the product 3m (10ft) or further from
the refuelling area and source before starting.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
331 - 011 - 15.11.2022
Assembly
Before you assemble the
Remove the spark plug
Safety instructions for maintenance
WARNING:
before you do any work on the
cutting attachment. The cutting attachment
continues to rotate even after the throttle
has been released. Ensure that the cutting
attachment has stopped completely and
disconnect the spark plug before you start
to work on it.
WARNING:
may increase the risk of accidents.
WARNING:
cord is wound tightly and evenly around the
drum, otherwise the product will generate
harmful vibration.
•
Only use cutting attachments with the guards we
recommend. Refer to
To attach the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the bolt. Do not tighten
the bolt fully.
4. Adjust the product to a correct position.
5. Tighten the bolt.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
Always stop the engine
A faulty cutting attachment
Make sure that the trimmer
Accessories on page 20 .
9