Table of Contents
Advertisement
3. In the system chassis, remove the blanking plate from the
corresponding expansion slot you want to use, and install an
extension bracket in there. Secure the extension bracket in the
chassis with a screw.
Extended IEEE1394 Header (optional)
You can obtain one IEEE1394 header JP2. Install them by
following the steps below.
1
1
JP2
JP2
Pin
Signal
1
CPWR
3
XTPB0M
5
XTPA0M
7
SHIELD
1. Locate the IEEE1394 header JP2 on the mainboard.
2. Plug the bracket cable onto the JP2 header.
3. In the system chassis, remove the blanking plate from the
corresponding expansion slot you want to use, and install
an extension bracket in there. Secure the extension bracket
in the chassis with a screw.
2: Mainboard Installation
Pin
Signal
2
GND
4
XTPB0P
6
XTPA0P
8
KEY
17
Advertisement
Table of Contents
