Table of Contents
Advertisement
cutout on the DIMM module with the notch on the
DIMM socket.
3. Install the DIMM module into the socket and press
it firmly down until it is seated correctly. The
socket latches are levered upwards and latch on to
the edges of the DIMM.
4. Install any remaining DIMM modules.
DDR SDRAM memory module table:
DDR 266
DDR 333
DDR 400
Note: We do not guarantee that all DDR 400 memory modules will
work properly with your mainboard.
Jumper Settings
Using a jumper cap to connect two pins is SHORT, removing it
from these pins, OPEN.
JP1: Clear CMOS Jumper
Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the Setup
Utility are incorrect and prevent your mainboard from operating.
To clear the CMOS memory, disconnect all the power cables from
the mainboard and then move the jumper cap into the CLEAR
setting for a few seconds.
3 DIMMs
3 DIMMs
2 DIMMs
1
JP1
11
Advertisement
Table of Contents
