Multitech MultiConnect MTC-L4G2D User Manual page 48

USING LINUX WITH THE L4G2D RADIO
#pap-max-authreq <n>
# Set the maximum time that pppd will wait for the peer to authenticate
# itself with PAP to <n> seconds (0 means no limit).
#pap-timeout <n>
# Set the CHAP restart interval (retransmission timeout for
# challenges) to <n> seconds (default 3).
#chap-restart <n>
# Set the maximum number of CHAP challenge transmissions to <n>
# (default 10).
#chap-max-challenge
# If this option is given, pppd will rechallenge the peer every <n>
# seconds.
#chap-interval <n>
# With this option, pppd will accept the peer's idea of our local IP
# address, even if the local IP address was specified in an option.
#ipcp-accept-local
# With this option, pppd will accept the peer's idea of its (remote) IP
# address, even if the remote IP address was specified in an option.
#ipcp-accept-remote
# Disable the IPXCP and IPX protocols.
# To let pppd pass IPX packets comment this out --- you'll probably also
# want to install ipxripd, and have the Internal IPX Network option enabled
# in your kernel.
noipx
# Exit once a connection has been made and terminated. This is the default,
# unless the `persist' or `demand' option has been specified.
#nopersist
# Do not exit after a connection is terminated; instead try to reopen
# the connection.
#persist
# Terminate after n consecutive failed connection attempts.
# A value of 0 means no limit. The default value is 10.
#maxfail <n>
# Initiate the link only on demand, i.e. when data traffic is present.
# With this option, the remote IP address must be specified by the user on
# the command line or in an options file.
# the interface and enable it for IP traffic without connecting to the peer.
# When traffic is available, pppd will connect to the peer and perform
# negotiation, authentication, etc.
48
/usr/doc/HOWTO/IPX-HOWTO.gz contains more info.
Pppd will initially configure
When this is completed, pppd will
MultiConnect
®
Cell MTC-L4G2D User Guide