Multitech MultiConnect MTC-L4G2D User Manual page 44

USING LINUX WITH THE L4G2D RADIO
# show the password string in the log message.
#show-password
# Use the modem control lines.
# flow control, as for the crtscts option.
# implemented.)
modem
# Set the MRU [Maximum Receive Unit] value to <n> for negotiation.
# will ask the peer to send packets of no more than <n> bytes. The
# minimum MRU value is 128.
# 296 is recommended for slow links (40 bytes for TCP/IP header + 256
# bytes of data).
#mru 542
# Set the interface netmask to <n>, a 32 bit netmask in "decimal dot"
# notation (e.g. 255.255.255.0).
#netmask 255.255.255.0
# Disables the default behaviour when no local IP address is specified,
# which is to determine (if possible) the local IP address from the
# hostname. With this option, the peer will have to supply the local IP
# address during IPCP negotiation (unless it specified explicitly on the
# command line or in an options file).
#noipdefault
# Enables the "passive" option in the LCP.
# attempt to initiate a connection; if no reply is received from the
# peer, pppd will then just wait passively for a valid LCP packet from
# the peer (instead of exiting, as it does without this option).
#passive
# With this option, pppd will not transmit LCP packets to initiate a
# connection until a valid LCP packet is received from the peer (as for
# the "passive" option with old versions of pppd).
#silent
# Don't request or allow negotiation of any options for LCP and IPCP
# (use default values).
#-all
# Disable Address/Control compression negotiation (use default, i.e.
# address/control field disabled).
#-ac
# Disable asyncmap negotiation (use the default asyncmap, i.e. escape
# all control characters).
#-am
# Don't fork to become a background process (otherwise pppd will do so
44
On Ultrix, this option implies hardware
(This option is not fully
The default MRU value is 1500.
With this option, pppd will
A value of
®
MultiConnect Cell MTC-L4G2D User Guide
pppd