Toshiba RAV-HM561UTP Series Service Manual page 88

<Wireless remote controller>
Wireless remote controller A-B selection
Using 2 wireless remote controllers for the respective air conditioners, when the 2 air conditioners are closely
installed. Address (A-B selection) must be changed on both signal receiving unit and wireless remote controller.
Wireless remote controller B setup
1. Push the START/STOP button to operate the air conditioner. Push it again to stop the air conditioner.
2. Push [Temporary] button on the signal receiving unit to operate the air conditioner.
3. Point the wireless remote controller at the indoor unit.
4. Push and hold
CHK
the display.
5. Push the MODE button during pushing
"B" will be shown on the display and "
wireless remote controller B is memorized.
1
5
COMFORT
SLEEP
4
"B" Display
"00" Display
Note:
• Repeat above step to reset wireless remote controller to be A.
• The wireless remote controllers do not display "A".
• The factory default of the wireless remote controllers is "A".
Signal receiving unit (A-B selection) setting
1. Turn off the indoor unit power supply.
2. Remove the screw on the signal receiving unit cover and then remove the signal receiving cover.
3. Turn on the bit 3 of DIP switch SW30 on the signal receiving unit P.C. board.
button on the wireless remote controller by the tip of the pencil. "
.
CHK
00
" will be disappear and the air conditioner will turn OFF. The
Signal receiving
unit cover
SWING FAN
FIX QUIET
Hi POWER
DIP switch SW30
Signal receiving
unit P.C. board
Receiving unit
SW30 bit 3:
OFF= Address A
ON = Address B
- 88 -
00
" will be shown on
Address A/B
Header/Follower
ON