Toshiba RAV-HM561UTP Series Service Manual page 108

No. Part name
1. Detachment
Ceiling panel
4
1) Carry out works of item 1 of
2) Remove the flap connector
NOTE :
Unlock the lock of the housing part and
then remove the connector.
3) Loosen the panel fixing 4 screws.
4) Slide the panel fixing brackets
5) Push the tentative bracket outward and
2. Attachment
1) Insert the tentative brackets (2 positions)
NOTE :
The ceiling panel has the directional
properties against the indoor unit.
Direct the louver motor wire to the electric
parts box side of the indoor unit.
2) Pass the head of the panel fixing screw
3) Tighten in the panel fixing screw to fix the
4) Following to work of item 2 of
5) Connect the louver connector
6) Following to work of item 2 of 2 , mount
Procedure
<RBC-U32P**>
of 3 .
(CN510, White, 20P) connected to the
control P .C. board and then remove the
lead wire from the clamp.
(4 positions) outward.
then remove the ceiling panel.
of the ceiling panel into square holes of
the indoor unit and then hook the panel
tentatively.
through hole of the panel fixing bracket
and then slide the panel fixing bracket
inward.
ceiling panel.
the adjust corner cap as before.
(CN510, White, 20P) as before and then
fix the lead wire with clamp.
the electric parts box cover and the
suction grille as before.
2 and item 1
Panel
fixing screw
Ceiling panel
Square
indoor unit
Push when releasing
Tentative bracket
Sliding direction
3 , attach
Inner side
- 108 -
Remarks
Clamper
CN510
Drain pipe
Square holes of
indoor unit
Electrical
control box
Refrigerant
pipe
Marking:
Drain pipe side
Louver motor wire
Marking:
Refrigerant pipe
Tentative bracket
side
hole of
Panel
fixing screw
Outer side
Panel
fixing bracket