Toshiba RAV-HM561UTP Series Service Manual page 109

No. Part name
1. Detachment
1) Carry out works of item 1 of
2) Remove the flap connector
NOTE :
Unlock the lock of the housing part and
then remove the connector.
3) Slide the panel fixing brackets (4 positions)
4) Push the tentative bracket outward and
2. Attachment
1) Insert the tentative brackets (2 positions)
NOTE :
The ceiling panel has the directional
properties against the indoor unit.
Direct the louver motor wire to the electric
parts box side of the indoor unit.
2) Pass the head of the panel fixing screw
3) Tighten in the panel fixing screw to fix the
4) Following to work of item 2 of
5) Connect the louver connector
6) Following to work of item 2 of 2 , mount
Procedure
<RBC-U33P**>
of 3 .
(CN510, White, 20P) connected to the
control P .C. board and then remove the
lead wire from the clamp.
outward. (Loosen the panel fixing 4 screws
when the panel fixing brackets do not
move.)
then remove the ceiling panel.
of the ceiling panel into square holes of
the indoor unit and then hook the panel
tentatively.
through hole of the panel fixing bracket
and then slide the panel fixing bracket
inward.
ceiling panel.
the adjust corner cap as before.
(CN510, White, 20P) as before and then
fix the lead wire with clamp.
the electric parts box cover and the
suction grille as before.
2 and item 1
Drain pipe
Panel
fixed screw
Ceiling panel
Tentative
hanging hook
Push to remove
3 , attach
- 109 -
Remarks
Clamper
CN510
Square
hole on the
indoor unit
Electrical
parts box
Refrigerant
pipe
Louver
motor wires
(Fig. 3)
Square hole of an
indoor unit
Tentative hanging hook
Panel fixing implement
Panel fixing screw