Hardware For Connecting Power Input Cables To The Bip - Nortel Passport 15000 Hardware Description

Table 9
BIP backplane power connections in a dual shelf frame
BIM Connector
A1 P15
P16
P17
B1 P 18
P19
P20
A2 P21
P22
P23
B2 P24
P25
P26

Hardware for connecting power input cables to the BIP

The cables that input power to the rear of the breaker interface panel (BIP)
can be connected by one of the following methods.
• directly to the studs on the rear of the BIP
• indirectly through one of the power-and-ground assemblies (described in
"Using an optional power-and-ground assembly" (page 76))
See the figure "Backplane connections at the BIP" (page 81). The power input
connections include the following parts for each BIM:
• one pair of studs for connecting one dc power input cable and one return,
that is, one feed
• one power input stud with an anti-rotation mate for each 2-hole lug
Chapter 2 Breaker interface panel 75
Connects to
PIM 15RU lower shelf
cooling unit lower shelf
PIM 7RU lower shelf
PIM 15RL lower shelf
lower cooling unit
PIM 7RL lower shelf
PIM 15RU upper shelf
upper cooling unit
PIM 7RU upper shelf
PIM 15RL upper shelf
upper cooling unit
PIM 7RL upper shelf
Passport 15000, 20000 Hardware Description 5.2S2