Cp Cables - Nortel Passport 15000 Hardware Description

Table 21
CP minimum software requirements for a Passport 15000
Order code
NTHR06CA,
NTHR35CA
NTHW06AA,
NTHW08AA
Table 22
CP minimum software requirements for a Passport 20000
Order code
NTHW06AA,
NTHW08AA

CP cables

CPs of a Passport 15000 or 20000 are installed in slots 0 and 1. (Slots 0E and
1E are reserved for later development and must contain blank processor cards
in the meantime.) Each control processor card has CP marked on its faceplate.
(A CP2 indicates CP2 while a CP3 indicates CP.)
The types of CP cables and their connectors depend on the kinds of
terminations on the faceplate of the CP2 or CP3, and on the equipment at the
other end. You must provide the cables and connectors that link a CP to Nortel
Networks equipment such as a local user interface terminal or a Preside
MDM workstation communicating through a router or hub of a local area
network (LAN), or to any other CPE termination.
Prefabricated cables are available for any CP. Each CP3 is shipped with its
own two cables. CP2 cables are available in optional kit NT0479, which
includes cable assemblies NT0460 and NT0477 as shown in the figures "CP2
Ethernet cable NT0460" (page 156) and "CP2 Ethernet crossover cable
NT0477 with RJ-45 connectors and ferrite bead" (page 157). On a CP3, ports
Chapter 4 Control and function processors 153
CP part description and software version
CP2s are supported with PCR1.1 and later releases.
CP3s are supported with PCR1.3 and later releases.
CP part description and software version
CP3s are supported with PCR 3.1 and later releases provided
each is migrated to the current PCR of the switch
Passport 15000, 20000 Hardware Description 5.2S2