Table of Contents
Advertisement
● Various camera models automatically adjust the Sync setting to HSS when HSS is enabled in the
camera settings, and the native sync speed has been exceeded.
● Ensure the camera's battery level is above 25%.
● Ensure the camera contacts are clean and the FJ-X3 is seated correctly and aligned properly.
FJ-X3: Getting Started
Charging
1.
Access the USB-C port on the left side of the FJ-X3.
2. Plug the USB-A to USB-C cable into the FJ-X3.
3. Plug the opposing end of the cable into any 5V power source.
4. The estimated charging time is 3 hours.
NOTE: During cold weather usage, the FJ-X3 battery charge may deplete quicker or show inaccurate
charge status.
Removing & Replacing the Battery
1.
Turn the FJ-X3 over with the battery cover facing upwards.
2. Apply slight pressure to the textured area and slide the battery cover in the direction of the arrow
to remove the battery cover.
3. Remove the battery by inserting your finger into the half-circle cutout above the
battery and lean the battery forward. Or, turn the FJ-X3 over and gently shake the unit over your
hand until the battery dislodges from the battery bay.
4. Reinsert a battery by aligning the 3 contact points on the battery with those
inside the battery bay. Angle the battery and gently insert into the battery bay. (NOTE: Never
force the battery into place.]
5. Ensure that the battery is seated flush by gently pressing it into place.
6. Reinstall the battery cover by laying the cover flat and covering ¾ of the battery. Use the textured
area to slide the battery cover toward the base of the FJ-X3 until it clicks into place.
FJ-X3: Mounting & Removing
Mounting to a Shoe (Hot/Cold)
1.
Turn the FJ-X3 OFF.
2. Looking at the FJ-X3 screen, turn the Shoe Lock dial to the right until it stops.
3. Gently slide the FJ-X3 into the camera's hot shoe.
4. Turn the Shoe Lock dial to the left to lock into place.
NOTE: Avoid turning the shoe lock too far to the left or right.
9
Advertisement
Table of Contents
