Removing From A Shoe (Hot/Cold); Mm Pc Port Connection [Output Only]; Mounting With The Adapter For Sony Cameras (Product #: 4711); Fj-X3: Powering On & Off - Westcott FJ-X3 User Manual

Wireless trigger

Hide thumbs Also See for FJ-X3:

Table of Contents

NOTE: Never force the FJ-X3 into a shoe.

Removing from a Shoe (Hot/Cold)

Turn the Shoe Lock dial to the right to unlock from the hot shoe.

2. It's vital that the Shoe Lock dial be rotated entirely until it stops so that the locking pin has

retracted into the base. [Failure to do this could cause permanent damage to the FJ-X3.]

3. Slide the FJ-X3 toward the back of the camera to remove it.

The 2.5mm port (output only) can be used to initiate wired synchronization with third-party strobes and

triggers that oﬀer a synchronization port (input). [cables sold separately]

NOTE: The Westcott FJ-XR Wireless Receiver (#4701) is equipped with a 3.5mm plug which adds FJ

Wireless Communication to 3rd-party strobes equipped with a 3.5mm sync port (input).

Slide the Adapter for Sony Cameras (sold separately) into the camera's hot shoe with the release

button facing the back of the camera.

2. Once the adapter is mounted, loosen the FJ-X3's Shoe Lock dial and slide the FJ-X3 into the

adapter's shoe.

3. Turn the FJ-X3 Shoe Lock dial to the left to lock it into place.

NOTE: Avoid turning the shoe lock too far to the left or right.

NOTE: Never force the FJ-X3 into a shoe.

FJ-X3: Powering On & Oﬀ

Long press the Power button for 3 seconds until you see the Westcott logo. The wireless signal indicator

will continually ﬂash green.

NOTE: Certain camera models may require the FJ-X3 trigger to be turned ON before turning on the

camera.

Power Oﬀ

Long press the Power button for 3 seconds until the screen turns oﬀ.

Table of Contents

Fj-x3m Fj-x3s