Getting Started - Westcott FJ-X3 Quick Start Manual

Getting Started

Charging the FJ-X3
1. Locate the USB-C port.
2. Plug the USB-A to USB-C cable into the FJ-X3.
3. Plug the opposing end of the cable in any 5V power source.
4. Estimated charging time is 3 hours.
Powering On & Off
• Power On: Long press and hold the Power button until you see the Westcott logo.
• Power Off: Long press and hold the Power button until the screen turns off.
Test Fire
Press the Test button once to remotely test-fire the FJ Wireless flash. When the Test
button is pressed the wireless signal indicator LED will illuminate red.
Trigger Settings Lock
• Long press and hold the CH | Lock button to lock the current tigger settings. A green
lock icon will appear on the display.
• Long press and hold the CH | Lock button again to unlock to adjust the settings.
Removing & Replacing the Battery
1. Turn the FJ-X3 to the side with the battery cover. Locate the textured and arrow
portions on the battery cover.
2. Apply slight pressure to the textured area and slide the battery cover in the
direction of the arrow.
3. Remove the battery cover.
4. Remove the battery by inserting your finger into the half-circle cutout above the
battery and leaning the battery forward, or turn the FJ-X3 over and gently shake
the battery until it's removed from the battery bay.
5. Reinsert the new battery by aligning the 3 contact points on the battery with those
inside the battery bay. Angle the battery and gently insert into the battery bay.
6. Ensure that the battery is seated flush by gently pressing into place.
7. Reinstall the battery cover by laying the cover flat and covering 3/4 of the battery.
Use the textured area to slide the battery cover towards the base of the FJ-X3 until
it clicks into place.