Table of Contents
Advertisement
Cell Tower
Antenna Installation
The antenna should be mounted as shown in the illustration above. The included
mounting bracket is adjustable and will accommodate pipe diameters from 1.25" to 2"
(pipe sold separately). Mount the antenna so that there is at least 3 feet of clearance in
all directions around it. Position the antenna so that it has the most unobstructed line of
sight to the cellular service provider's strongest signal. If you are using a wireless signal
booster, make sure the antenna is not pointing across your own roof.
Warning: Lightning protection is recommended for all installations (Wilson
Electronics 50 Ohm Part# 859902 or 75 Ohm Part# 859988). Take extreme care to
ensure that neither you nor the antenna comes near any electric power lines.
Cell Tower
Adjusting the Antenna for Maximum Performance
To adjust the antenna for best performance, connect it to your cell phone with an external
adapter and a length of coaxial cable. External antenna adapters and coaxial cables
are sold separately. Put the cell phone in test mode and turn the Antenna in 10-degree
increments while checking the cell phone's signal level. At each point you may need to
wait a few seconds as your cell phone updates. To find your phone's test mode, visit
www.WilsonElectronics.com. Signal readings usually appear as a negative number (for
example, -86). The larger the number, the more powerful the signal (-75 is stronger than
-84).
Antenna Adapter
An external adapter may be required to connect your cellular data card directly to the
antenna. The external adapter is specific and may be purchased through a local retailer.
Important: If you are using a wireless signal booster, be sure the Antenna is not
pointing across the building in which you are trying to get coverage. The antenna
should point away from the building to help prevent oscillation (feedback).
Once you have obtained the strongest signal, fully tighten the mounting hardware.
Ultra low loss coax is recommended for lengths 20' or greater to prevent significant
signal loss. Wilson Electronics offers cable in several lengths from 20-1000 feet. Wilson
Electronics also offers a wide range of phone adapters to connect your cell phone to a
signal booster, or directly to the antenna.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Drip hole on bottom
RF Signal
Wide Band
Antenna
2
Advertisement
Table of Contents
