Table of Contents
Advertisement
Product description
Hazardous area
To eliminate the risk of danger to persons or the facility when the device is used in the
approval-related area (e.g. explosion protection, pressure equipment safety):
‣
Check the nameplate to verify if the device ordered can be put to its intended use in the
approval-related area.
‣
Observe the specifications in the separate supplementary documentation that is an integral
part of this manual.
2.5
Product safety
This device is designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, has been tested, and left the factory in a condition in which it is safe to
operate.
It meets the general safety standards and legal requirements. It also complies with the EU
directives listed in the device-specific EU Declaration of Conformity. The manufacturer
confirms this by affixing the CE mark to the device.
3
Product description
Device for measuring low-density bulk solids with conductivity values up to 1 mS/cm.
3.1
Product design
1
Product design
1
Wave guide
2
Measuring cell; TECAPEEK
3
Housing
3.1.1
Remote electronics (accessories)
In the case of the order option Accessories mounted: remote electronics 120 °C (248 °F),
the electronics module is located in a separate housing and is connected using the HF cable
that is permanently connected to the sensor.
6
Solitrend MMP60
1
2
3
Endress+Hauser
A0040364
Advertisement
Table of Contents
