Table of Contents
Advertisement
2.2
Connecting and Removing
Attachments
All attachments for the PowerPro Pneumatic
Modular Handpiece connect/disconnect in the
same manner. For more information, refer to the
PowerPro Attachment Instruction Manual or the
Information Insert supplied with each attach-
ment.
1. To connect an attachment:
(a) Place the safety/directional lever in the
safe position.
(b) Orient the attachment shaft to the hand-
piece opening. Insert the shaft and
press them until they snap together.
2. To disconnect an attachment, twist the
attachment collet-locking ring in a clock-
wise direction and remove the attachment.
2.3
Handpiece Mode Selection and
Operation
PowerPro
2.3.1
Handpiece (PRO6150) Operation
The PowerPro Pneumatic Modular handpiece,
in conjunction with numerous attachments, is
used for drilling, and wire and pin driving. It has
a variable speed of 0-1250 rpm and a minimum
torque of 20 in. lbs. with all drilling, and wire
and pin driving attachments. A variable speed of
0-250 rpm and torque of 100 in. lbs. with the 5:1
ratio reaming attachment (identified with a blue-
colored ring).
1.
To operate the handpiece, place the hand-
piece safety/direction lever in either the for-
ward or reverse position and depress the
trigger.
(a) With the safety/direction lever in the
forward position, depressing the trigger
operates the handpiece in the clockwise
direction as viewed from the rear of the
handpiece.The speed is variably con-
trolled by the trigger.
(b) With the safety/direction lever in the
reverse position, depressing the trigger
operates the handpiece in the counter-
clockwise direction as viewed from the
rear of the handpiece. The speed is
variably controlled by the trigger.
10
Pneumatic Modular
Advertisement
Table of Contents
