Acpi Steeings - DFI ADS310-R680E/Q670E User Manual

Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
Resolution 100x31
Enables or disables extended terminal resolution.
Putty Keypad
Select FunctionKey and KeyPad on Putty.
• VT100
• LINUX
• XTERMR6
• SCO
• ESCN
• VT400
User's Manual | ADS310-R680E/Q670E
Advanced
X

ACPI Steeings

Aptio Setup - AMI
Advanced
ACPI Settings
Wake system from S5 via RTC [Disabled]
State After G3 [S0 State]
Version 2.22.1284. Copyright (C) 2022 AMI
Wake system from S5 via RTC
Enable or disable System wake on alarm event. When enabled, System will wake on the
hr::min::sec specified
State After G3
Select between S0 State, and S5 State. This field is used to specify what state the system is
set to return to when power is re-applied after a power failure (G3 state).
S0 State
The system automatically powers on after power failure.
S5 State
The system enter soft-off state after power failure. Power-on signal input is required to
power up the system.
Last State
The system returns to the last state right before power failure.
Chapter 3 Chapter 3 Chapter 3
BIOS SETTINGS BIOS SETTINGS BIOS SETTINGS
Enable or disable System
wake on alarm event. When
enabled, System will wake
on the hr::min::sec speci-
fied
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
45 45 45