superbrightleds USP Series User Manual

Important: Read all instructions prior to installation.
Universal Switch Panel Kit

Layout / Wiring

Switch Control Panel
1 2 3
5 6 7
switch button master on/off
(turns all connected lights
and accessories on/off)
to switched / ignition on power

Button Settings

When the fuse/switch box and switch control panel are connected and powered
on, the default setting for each button will be to function as a simple on/off switch
for the connected light or accessory.
Buttons on the switch panel can also be set to a momentary setting or a strobe
setting. This can be done by first holding down the master on/off button, then
holding any button until the light above that button illuminates. This process can
be repeated to cycle through the three settings as needed.
4
8
8 7
5 A 5 A
red white
to momentary switch for dimming
Fuse/Switch Box
6 5 4 3 2
10 A 10 A
20 A 20 A
30 A
Rev Date: V1 12/14/2021
4400 Earth City Expy, St. Louis, MO 63045
User Manual
USP Series

Safety and Notes

• To reduce the risk of electric shock, ensure the
main power source (battery) is disconnected before
performing any installation or wiring procedures.
• Do not exceed the maximum of 60 A combined
across all output channels.

Specifications

Environmental Specifications

Operating Temperature -40°–221° F(-40°–105° C)
1
30 A
ground (-)
866-590-3533
positive (+)
Circuit Breaker
superbrightleds.com