Table of Contents
Advertisement
Bluetooth
(PL-485-BT)
cal since it can be used to quickly connect to Prolon controllers that
are equipped with a similar RJ45 jack using a standard CAT5 cable
(included). This approach saves time since there is no need to cut and
strip wires.
Note: The RJ45 jack is NOT an ETHERNET port. The PL-485-BT does
NOT SUPPORT ETHERNET.
The RS485 TXD and RXD LEDs blink briefly as bytes are being transmit-
ted or received respectively over the RS485 line, but do not indicate the
validity or comprehension of these bytes by the equipment.
The RS485 circuitry in the PL-485-BT is electrically isolated from the USB
circuitry, thereby avoiding any potentially hazardous GND loops with
your PC.
Battery Precautions
• Do not attempt to replace the battery. It is built-in and not
changeable.
• Charge your converter using a certified computer, powered hub
or power supply.
• Charge the battery in accordance with the instructions supplied
with this guide.
• Use only the charger cable that shipped with your product to
charge the battery.
6
REV 6.0 / PL-QCK-MIX-EN
Regulatory and Safety Notices
Model Name: PL-485-BT
USA: Federal Communications Commission (FCC) Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
FCC Warning:
Changes or modifications not expressly approved by Prolon Inc. could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
REV 6.0 / PL-QCK-MIX-EN
7
Advertisement
Table of Contents
