Lorex L20WD800 Series Quick Start Manual page 3

SET UP YOUR MONITOR FIRST
STEP 1
1
2
3
LEFT
RIGHT
CLICK CLICK
www.lorexcctv.com
Connect Cameras to the monitor:
Your system includes 4 high resolution
6 PIN DIN cameras.
* Connect cameras to extension cables
by aligning the arrows. Plug in cameras
and cables before mounting the cameras.
TIP: Test the cameras prior to selecting
a permanent mounting location by NOTE: The arrow mark on top of the flat side of
temporarily connecting the Cameras the camera and cable connectors should face
and Cables to your System.
UP while inserting to the Monitor.
Connect the first camera to the CH1
input. Follow the same steps to connect
the additional cameras.
Connect Ethernet Cable:
Connect one end of the Ethernet cable (for remote
monitoring) to one of the router's (not included) LAN
ports and the other end to Monitor's Network Port
located at the back of the Monitor.
See picture below showing a generic LAN/WAN
connection.
WAN
LAN (LOCAL AREA NETWORK)
(WIDE
AREA NETWORK)
BACK OF THE ROUTER
TO YOUR MONITOR
TO YOUR COMPUTER
Connect the mouse:
Connect a USB mouse to one of the USB
ports located at the side of the monitor.
4
1
5
1
2
3
4
under 15 minutes under 30 minutes
BASIC INSTALLATION GUIDE
Hand Tools
Time Tools Skills - Easy
Under 20 Minutes* hand Tools
* Installation time may vary based on
application and camera cabling
Skill Level
Connect Power Cable:
easy
Connect one end of the Power adaptor to the monitor,
the other end to an electrical outlet.
Your system will perform the following System Check:
1. Blue LED at the front flashes four times
2. You will hear 2 beeps
3. Power LED at the front turns RED
PrESS ThE POwEr buTTON ON
Your system will load with screens shown below.
NOTE: THIS MAy TAKE UP TO 15 SECONDS. PLEASE wAIT
UNTIL THE SySTEM COMPLETES LOADING.
3
2
Monitor Front Panel - Power Button
Set the Time and date***:
Time and Date can be set by
• Pressing the SETUP button from the front panel of the monitor
• Pressing the SETUP button from the remote control (or) by
• Using the mouse navigation (recommended)
1. Right click the mouse and select SETUP and click on SYSTEM SETUP
2. On SYSTEM SETUP MAIN Menu, select SYSTEM
3. Click on the DATE/TIME menu and use the UP and DOWN arrows to
change the DATE/TIME.
4. Click Apply. The system will prompt you for default USER ID and
PASSWORD.
MAKE SURE THAT THE
DATE AND TIME ARE SET
PRIOR TO RECORDING!
THE DEFAULT USER IS ADMIN
THE DEFAULT ADMIN PASSOWRD IS 124

Congratulations!
You have completed Step 1 successfully.
You can now view, record and playback
images on your monitor.
L20WD800 SERIES Series Quick Start Guide_R2
R
under 60 minutes over 60 minutes
Skill Level
Hardware Hi Speed
Router
easy Intermediat
Plug & Play connectors,
On screen set up
Intermediate advanced
*** NOTE: IF THE DATE/
TIME IS SET INTO THE
PAST, A MESSAGE wILL
APPEAR wARNING THAT
OvERLAPPED DATE(S)
wILL BE ERASED.
Page