Lorex L20WD800 Series Quick Start Manual page 10

MULTIFUNCTION SYSTEM / MODES
4
PICTurE frAmE mOdE:
PIP
(PICTurE-IN-PICTurE)
Picture Frame Mode is used to display JPG images located on a USB
Thumbstick (connected to a USB Port on the side of the monitor).
To view a JPG Images using Picture Frame Mode:
1. Connect a USB Thumbstick containing JPG images to the Monitor,
using one of the USB ports located on the side. JPG images cannot
exceed 1600 x 1200 pixels.
NOTE: A USB THUMBSTICK IS NOT INCLUDED wITH THE SySTEM.
2. Switch the Monitor to Picture Frame Mode using the Multi-function
Mode button on the front of the Monitor, or by pressing the Picture
Frame Button on the Remote Control.
3. Configure the Picture Frame Menu to display the images.
If you press the PIP button on your remote control you can view your
DVR in a Picture In Picture. This provides you with the ability to view
images from your cameras while looking at your pictures.
www.lorexcctv.com
(CONTINUED)
5
INSTALLATION GuIdE mOdE:
Displays the system installation video (12 minutes).
NOTE: THE INSTALLATION vIDEO IS ALSO LOCATED ON THE CD. yOU
CAN ALSO vIEw IT ON LINE AT www.LOREXCCTv.COM/SUPPORT
IN THE CONSUMER GUIDES SECTION.
IT IS HIGHLY RECOMMENDED TO VIEW
OUR EASY TO FOLLOW INSTALLATION
VIDEO. YOU CAN PAUSE, REWIND OR FAST
FORWARD TO ALLOW YOU TO INSTALL THE
SYSTEM WITH STEP BY STEP
INSTRUCTIONS.
6
Pvm (PubLIC vIEw mONITOrING):
You can connect a slave monitor (not included) to the
system using the "Spot Out" output.
You can configure which channels will be displayed on
the slave monitor.
This feature is used for situations in which you want to
have the system in a back room while still displaying
images to the public eye, for deterrence or advertising
purposes.
L20WD800 SERIES Series Quick Start Guide_R2
Slave Monitor (not included)
Page 10