Table of Contents
Advertisement
Hardware Manual for the DMC5400 Motion Controller
Chapter 2 Installation
This chapter describes how to install the DMC5400. The DMC5400 automatically configures the port and BIOS
addresses. It is not necessary to configure the addresses, hence avoiding addressing conflicts.
2.1 Package Contents
Besides this User's Manual (Electronic Edition), the package also includes the following items:
• DMC5400 4-axis Servo/Stepping Motion Control Card (1 piece)
• TB68 Terminal Board (1 piece)
• Cable68-2.0 (1 piece)
• TB50 Terminal Board (optional)
• Cable50-2.0 (optional)
• 50-pin IDE to 50-pin MCR connector with bracket (Optional)
• Leadshine All-in-one CD
See "Order Information" section for more information about package contents.
If any of these items are missing or damaged, contact the dealer from whom you purchased the product or
Leadshine.
2.2 Unpacking
As with any electronic device, you should take care while handling to avoid damage from static electricity. Before
removing the DMC5400 from its packaging, ground yourself to eliminate any stored static charge. The card
contains electro-static sensitive components that can be easily damaged by static electricity. Therefore, the card
should be handled on a grounded anti-static mat. Inspect the card module carton for obvious damage. Shipping
and handling may cause damage to your module. Be sure there is no shipping and handling damage on the carton
before continuing.
Note:
Do not attempt to install a damaged board in the computer.
2.3 Hardware Installation
The DMC5400 is equipped with Plug and Play PCI controllers. It can request base addresses according to PCI
standards. The system BIOS will install the system resources based on the PCI cards' configuration registers and
system parameters (also can be set by the system BIOS). The DMC5400 can be inserted into any PCI slot without
any configuration modification to the system resources. Please note that the PCI system board and slot must
provide bus-mastering capabilities to operate at optimum level. See "Power Consumption" section in page 3.
Installation Procedures
1. Turn off your computer.
Tel: +086 0755-26434369
Email: sales@leadshine.com
Web Site: www.leadshine.com
Page: 5/36
Advertisement
Table of Contents
