Table of Contents
Advertisement
The Motion5000 Demo software, a Microsoft Windows based software is equipped with the DMC5400 card for
supporting application development. The Motion5000 Demo software is very helpful for verifying and testing a
motion control system during the design phase of a project.
You will see the default window, namely Motion Configuration Window like Figure6.1 after running the
Motion5000 demo software. The Motion5000 includes 4 main windows. They are Motion Configuration Window,
I/O Status/Control Window, Controller Configuration Window and Function Testing Window. There are four
buttons on the Main Toolbar
Figure 6.1: Motion5000 demo software (the Motion Configuration Window, the default window)
Main Toolbar
1.
New File Button. It can be used to open a new program file, and it's only active in the Function Testing
Window.
2.
Open File Button. It can be used to open an existed program file, and it's only active in the Function
Testing Window.
3.
Save File Button. It can be used to save a program file, and it's only active in the Function Testing
Window.
4.
Run Program Button. It can be used to run a program file, and it's only active in the Function Testing
Window.
5.
Emergency Stop Button. It can be used to stop a running a program file.
Tel: +086 0755-26434369
Chapter 6 Motion5000 Demo Software
which can be used to switch these four windows.
Email: sales@leadshine.com
Hardware Manual for the DMC5400 Motion Controller
Page: 24/36
Web Site: www.leadshine.com
Advertisement
Table of Contents
