D-Link DIR-882 User Manual page 103

DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Parameter
RIP
RIPng
Figure 86. The page for creating a new PPPoE IPv6 connection. The Ethernet section.
Parameter
MAC address
MTU
For the PPPoE Dual Stack type only.
Move the switch to the right to allow using RIP for this connection.
Move the switch to the right to allow using RIPng for this
connection.
Ethernet
A MAC address assigned to the interface. This parameter is
mandatory if your ISP uses MAC address binding. In the field, enter
the MAC address registered by your ISP upon concluding the
agreement.
To set the MAC address of the network interface card (of the
computer that is being used to configure the router at the moment)
as the MAC address of the WAN interface, move the Clone MAC
address of your NIC switch to the right. When the switch is
moved to the right, the field is unavailable for editing.
To set the router's MAC address, click the RESTORE DEFAULT
MAC ADDRESS button (the button is available when the switch is
moved to the right).
The maximum size of units transmitted by the interface.
Page 103 of 303
Configuring via Web-based Interface
Description
Description