Table of Contents
Advertisement
M68ICS08JB In-Circuit Simulator
MOTOROLA
– Executing real-time in RAM or FLASH
– Placing one hardware breakpoint in FLASH
– Placing multiple breakpoints in RAM
•
On-line help documentation for all software
•
Software integrated into the WinIDE environment, allowing function
key access to all applications
•
MON08 emulation connection to the target system allowing:
– In-circuit emulation
– In-circuit simulation
– In-circuit programming
•
Four modes of operation:
– Standalone — using the JBICS as a standalone system without a
target board
– Simulation — using the JBICS as an in-circuit simulator/emulator
with a target cable
– Evaluation - using the JBICS for real-time evaluation of the MCU
and to debug user developed hardware and software
– Programming — using the JBICS as a programmer
•
With the ICD08SZ debugging software, code may be run directly out of
the MCU's internal FLASH at real-time speeds.
•
With the WinIDE, CASM08Z, editor, simulator, and assembler software
- the function is as a limited real-time emulator.
•
With the PROG08SZ software - the function is to program MCU FLASH
memory.
•
With the ICS08JBZ simulation software, the MCU provides the required
input/output information that lets the host computer simulate code,
performing all functions except for maintaining port values. (The
internal FLASH memory on the device is downloaded with a program
that generates the appropriate port values.) The ICS08JBZ software on
the host computer lets the host computer become a simulator.
•
With using the ICD08SZ debugging software, code can be run directly
out of the MCU's internal FLASH at real-time speeds.
General Information
General Information
Introduction
User's Manual
13
Advertisement
Table of Contents
