Usb Connector - Motorola M68ICS08JB User Manual

Preparation and Installation

2.2.6 USB Connector

User's Manual
24
The USB connector is directly connected to the MCU USB interface through
the USB data pins (D+ and D-). If the development starts without the target
board, the user can connect the USB interface to the host by using a USB
standard detachable cable (Series "A" plug to Series "B" plug). In this case, a
shunt should be place in the jumper W5 to connect the 1.5Kohm pull-up
resistor.
Refer to Section 3, Support Information for pin assignment information.
Preparation and Installation
M68ICS08JB In-Circuit Simulator
MOTOROLA