Texas Instruments TRF0206-SP User Manual
Texas Instruments TRF0206-SP User Manual

Texas Instruments TRF0206-SP User Manual

Evaluation module

Advertisement

Quick Links

www.ti.com
User's Guide
TRF0206-SP Evaluation Module
The basic steps and functions that are required to ensure the proper operation and quick setup of the TRF0206-
SP-EVM is provided in this user's guide. This document also includes a schematic diagram, a bill of materials
(BOM), printed-circuit board (PCB) layouts, and test block diagrams. The abbreviations EVM, TRF0206-SP
EVM, and the term evaluation module throughout this document are synonymous with the TRF0206-SP-EVM,
unless otherwise noted.
1 Description..............................................................................................................................................................................
1.1 Features.............................................................................................................................................................................
1.2 General Usage Information................................................................................................................................................
2 EVM Overview.........................................................................................................................................................................
2.1 Schematic..........................................................................................................................................................................
2.2 PCB Layers........................................................................................................................................................................
Material........................................................................................................................................................7
3 Test Setup Diagrams..............................................................................................................................................................
Setup.....................................................................................................................................................8
Setup.....................................................................................................................................................9
3.3 Two-Tone OIP3 Test Setup..............................................................................................................................................
4 Related Documentation........................................................................................................................................................
Layer...................................................................................................................................................................5
Figure 2-3. Layer 2......................................................................................................................................................................
Figure 2-4. Layer 3......................................................................................................................................................................
Figure 2-5. Bottom Layer.............................................................................................................................................................
Figure 2-6. TRF0206-SP EVM Stack-Up (Units in Mils)..............................................................................................................
Figure 3-1. S-Parameter Test Setup............................................................................................................................................
Figure 3-3. Noise Figure Test Setup............................................................................................................................................
Figure 3-4. OIP3 Test Setup......................................................................................................................................................
Table 2-1. TRF0206-SP EVM BOM.............................................................................................................................................
Trademarks
Isola
®
is a registered trademark of Isola USA Corporation.
All trademarks are the property of their respective owners.
SLAU877 - OCTOBER 2022
Submit Document Feedback
ABSTRACT

Table of Contents

Material......................................................................................................................................6
List of Figures
P1dB...........................................................................................................2
Schematic...................................................................................................................................4
Frequency..................................................................................................................................9
List of Tables
Copyright © 2022 Texas Instruments Incorporated
Table of Contents
TRF0206-SP Evaluation Module
2
2
2
4
4
5
8
10
11
5
5
5
7
8
9
10
6
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRF0206-SP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Texas Instruments TRF0206-SP

  • Page 1: Table Of Contents

    SP-EVM is provided in this user's guide. This document also includes a schematic diagram, a bill of materials (BOM), printed-circuit board (PCB) layouts, and test block diagrams. The abbreviations EVM, TRF0206-SP EVM, and the term evaluation module throughout this document are synonymous with the TRF0206-SP-EVM, unless otherwise noted.
  • Page 2: Description

    Description www.ti.com 1 Description The TRF0206-SP evaluation module (EVM) is used to evaluate the TRF0206-SP device, which is a single-ended input to differential output radiation hardened RF amplifier available in a 6.00 mm × 6.10 mm , 12-pin LCC-FC package. The device is designed to drive a high-speed differential input ADC without using a passive balun.
  • Page 3 Figure 1-1, use an RF band pass filter when measuring single tone distortion. b. The RF signal generator used must support up to 12-GHz signal frequency for testing the TRF0206-SP EVM. c. The TRF0206-SP device input is 50-Ω in the pass-band.
  • Page 4: Evm Overview

    This section includes the schematic diagram, a bill of materials (BOM), PCB layer prints, and EVM stack-up information. 2.1 Schematic Figure 2-1 shows the TRF0206-SP EVM schematic. Figure 2-1. TRF0206-SP EVM Schematic TRF0206-SP Evaluation Module SLAU877 – OCTOBER 2022 Submit Document Feedback...
  • Page 5: Pcb Layers

    Figure 2-5 show the PCB layers for this EVM. Figure 2-3. Layer 2 Figure 2-2. Top Layer Figure 2-4. Layer 3 Figure 2-5. Bottom Layer SLAU877 – OCTOBER 2022 TRF0206-SP Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 6: Trf0206-Sp Evm Bill Of Material

    EVM Overview www.ti.com 2.3 TRF0206-SP EVM Bill of Material Table 2-1. TRF0206-SP EVM BOM Item # Designator Quantity Value Part Number Manufacturer Description !PCB AMPS181 Printed Circuit Board C1, C2, C3, C4 0.1 µF ATC530L104KT16T AT Ceramics CAP, CERM, 0.1 µF, 16 0402 V, ±...
  • Page 7: Stack-Up And Material

    EVM Overview 2.4 Stack-Up and Material The TRF0206-SP EVM is a 67-mil, 4-layer board whose material type is Isola ® 185HR. The top layer routes the power, ground, and signals between SMA connectors and the device. Second layer is the reference RF ground layer.
  • Page 8: Test Setup Diagrams

    3. Make sure the frequency sweep and output power level from the VNA is set within the linear operating range of the TRF0206-SP devices. The resolution bandwidth (RBW) and dynamic range of the VNA can be adjusted to give optimum sweep time for the measurement.
  • Page 9: Noise Figure Test Setup

    4. If the loss after the device output is significant, then it is important to factor the output loss into the NF measurement. Use the Friis equation to calculate the NF of the device from the total measured NF. SLAU877 – OCTOBER 2022 TRF0206-SP Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 10: Two-Tone Oip3 Test Setup

    7. For output IP3 calculation, take into account combined losses at the desired frequency band between the TRF0206-SP device output to the spectrum analyzer input. The combined power loss is due to PCB output trace, RF coax cable, 0/180° passive balun, and any attenuator pad used for external matching purposes.
  • Page 11: Related Documentation

    Related Documentation 4 Related Documentation For related documentation, see the following: • Texas Instruments, TRF0206-SP Single Channel, 10 MHz to 6.5 GHz 3-dB BW, ADC Driver Amplifier data sheet SLAU877 – OCTOBER 2022 TRF0206-SP Evaluation Module Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 12 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
  • Page 13 www.ti.com Regulatory Notices: 3.1 United States 3.1.1 Notice applicable to EVMs not FCC-Approved: FCC NOTICE: This kit is designed to allow product developers to evaluate electronic components, circuitry, or software associated with the kit to determine whether to incorporate such items in a finished product and software developers to write software applications for use with the end product.
  • Page 14 www.ti.com Concernant les EVMs avec antennes détachables Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à...
  • Page 15 www.ti.com EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS. 4.2 User must read and apply the user guide and other available documentation provided by TI regarding the EVM prior to handling or using the EVM, including without limitation any warning or restriction notices.
  • Page 16 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2019, Texas Instruments Incorporated...
  • Page 17 TI products. TI’s provision of these resources does not expand or otherwise alter TI’s applicable warranties or warranty disclaimers for TI products. TI objects to and rejects any additional or different terms you may have proposed. IMPORTANT NOTICE Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2022, Texas Instruments Incorporated...

This manual is also suitable for:

Trf0206-sp-evm

Table of Contents