8 iSolarCloud App
Tap the switch to enable the charger.
Tap the switch again to disable the charger, in this case the charger will be in "Disable"
status.
8.11.4 Start/Stop Switch
If the charging cable is inserted into the EV, and the parameters are set, the charger will be
in a "Standby" status. Tap
Charging". Pull out the charging cable after the charge is completed.
If the charger is in a "Unplugged" status after the charging mode is set, the
charging cable may not be inserted in place. Check the connection or reconnect
the cable to the EV.
To stop charging during the charging process, tap
"Charging" to "Complete".
110
figure 8-24 Parameter Setting
, the charger starts working and turns from "Standby" into "-
. At this time, the charging status from
User Manual