Advanced Properties; Advanced Properties For Windows 95, 98, Me, And 2000 - Linksys WPC11 User Manual

3. Highlight Protocol and
click the Add button.
4. Select Microsoft
from the list of
"Manufacturers"
and TCP/IP from
the list of "Network
Protocols" and click
the OK button.
5. Repeat steps two through four to install other protocols such as NetBEUI or
IPX/SPX.
From the screen in step two,
you can also press the
Properties button. From this
screen, you can verify that
the drivers are working under
Enhanced Mode on the
Driver Type tab or reconfig-
ure the card on the Advanced
tab.
At this point, you must
restart your computer.
Installation is complete.
38
Instant Wireless Series
TM Network PC Card

Advanced Properties

The Advanced Properties for Windows 95, 98, ME, and 2000
The Advanced Properties of the card are supplied for fine tuning the card's set-
tings. These values should only be changed by those completely familiar with
both the operating system and the settings of the network. Unless your specif-
ic situation requires changing them, the default settings should be sufficient for
your card's proper operation. Linksys advises that you change these values in
the Configuration Utility rather than using this method, to ensure that the set-
tings you change will be recognized everywhere.
If you have questions or are unsure, check your wireless network settings
before changing any of these values.
1. To access the Instant Wireless Network PC Card Properties V2.5 screen
(shown below), click the Start button, and choose Settings and then Control
Panel. Double-click the Network icon and choose the Advanced tab.
39