Steal Bit; Symbol Rate; Sync Output Configuration - Type, Timeslot, Offset - Agilent Technologies ESG Series User And Programming Manual

ESG Family Signal Generators
Options UN8 and 202

Steal Bit

[:SOURce]:RADio:GSM:SLOT0|[1]|2|3|4|5|6|7:NORMal:STeal <1 bit_pattern>
[:SOURce]:RADio:GSM:SLOT0|[1]|2|3|4|5|6|7:NORMal:STeal?
This command enables you to specify the normal steal bits for the selected timeslot. The
single bit defines the value for both 1-bit fields.
Range: 0 to 1
*RST value: 0

Symbol Rate

[:SOURce]:RADio:CUSTom:SRATe <value>
[:SOURce]:RADio:CUSTom:SRATe?
[:SOURce]:RADio:CUSTom:BRATe <value>
[:SOURce]:RADio:CUSTom:BRATe?
[:SOURce]:RADio:<desired format>:SRATe <value>
[:SOURce]:RADio:<desired format>:SRATe?
[:SOURce]:RADio:<desired format>
[:SOURce]:RADio:<desired format>
1
All formats except EDGE
This command sets the transmission symbol rate.
NOTE The BRATe SCPI command sets the bit rate. The bit rate is adjusted to reflect
symbol rate dependent on the number of bits per symbol for the modulation
type.
Range: 47.684 sps through 12.5 Msps, depending on the modulation type.
*RST value:
• Custom: 24.300000 ksps
• DECT: 1.152000 Msps
• EDGE: 270.833333 ksps
• GSM: 270.833333 ksps
• NADC: 24.300 ksps
• PDC: 21.00000 ksps
• PHS: 192.000 ksps
• TETRA: 18.000 ksps
Sync Output Configuration - Type, Timeslot, Offset
Synchronization Output Type
[:SOURce]:RADio:<desired format>:SOUT FRAME|SLOT|ALL
[:SOURce]:RADio:<desired format>:SOUT?
This command sets the type of output at the EVENT 1 connector. The choices are:
Outputs a 1-bit signal to the EVENT 1 rear panel connector that is
FRAME
Real-Time I/Q Baseband Generator User's and Programming Guide
1
:BRATe <value>
1
:BRATe?
Programming Commands and Examples
Programming Commands
4-71