Advertisement
Step 1 Install rail and motor
Installation effect picture
Drive Unit
RJ11 Cable
The curtain hook mounting position:
■
Hook unit —> Fixed hole—> Roller runner—> Master carrier and its handle.
Master, Slave:
■
The host is connected to AC220V, and it provides the power supply to the slave by the 6-core RJ11. The standard length of
RJ11 wire is 1 meter.
Ceiling bracket's mounting distance：
■
From both ends to the middle, it recommends to install a ceiling bracket and the distance is 600mm per (cannot exceed
600mm). In the middle rail, the ceiling bracket distance can be slightly long, the recommended distance is 800mm. (Because
the load in the ends is big, the mounting distance of ceiling bracket should to be short, and the load in the middle rail is small,
the distance of ceiling bracket can be slightly long)
Step 2 Wireless setting
Press the programming button 3 times, green LED will flash quickly and the wireless curtain motor enters gateway setup mode.
■
Open HDL-BUS Pro Setup Tool, search wireless gateway, choose Node configuration.
■
Click the "enter gateway setup mode".
■
And then, search, gateway and curtain will connect, check the curtain, modify the subnet ID and device ID, finally save address-
■
modify settings of selection-all node exit setup.
Note: The subnet ID of wireless curtain should be same as the gateway.
2
3
Professional Home and Building Automation
www.hdlautomation.com
Ceiling Bracket
Fixed Hole
Master Carrier
Hook Unit
Master
1
Ceiling Bracket
Rail
Roller Runner
Slave
4
Do you need help? Contact with us
support@hdlchina.com.cn
Wireless curtain motor
HDL-MWM70-RF.12
Drive Unit
Latch
RJ11 Cable
3/ 7
Advertisement
