Advertisement
Dimensions and wiring
Programming button
50
70
Latch
284
AC220V power line, 1 meter.
(Brown for L, Blue for N, Y/G for PE)
LED indicator
Function
Working properly
Modify the address of motor
Testing for installation
Easy programming
Wireless setting
Note: The above operations are carried out in normal work.
Safety Precautions
Do not make wrong connection on Bus interface, it will damage the Bus interface of this module.
■
Never let liquids get into the module, it will damage this device.
■
Ensure good ventilation
■
Avoid contact with liquids and aggressive gases
■
When you install the motor to the drive unit, please check and make sure that the latch is pushed into locked hole, otherwise the
■
motor will fall down to cause personal injury and product damage
When the motor is installed, please do not pull the curtain with too mush force, and do not put any additional weight on the rail, do
■
not climb the curtain and do not hang anything on the curtain.
Professional Home and Building Automation
www.hdlautomation.com
ANT
LED indicator
6P interface
Dry contact switch, control the curtain to open, close, stop（COM+FROW is
open, COM+REV is close, COM+STP is stop）
RJ11 6P network port, connect to the master and slave. It
supplies the working voltage for slave.
LED status
LED flashes, 1 time/2s
LED flashes
LED flashes, 1 time/2s
LED flashes, 2 times/2s
LED flashes
Unlock
Latch
Lock
Motor terminal
Motor terminal: Pull the latch to unlock direc-
tion, and then insert the motor terminal into the
C-Driver Unit. Then, put the latch into the
locked hole.
Enter into the status
－－
Long press the button for 3s
Long press the button for 5s
Long press the button for 10s
Press the button 3 times and
the pressing interval times
should not exceed 2S
Do you need help? Contact with us
support@hdlchina.com.cn
Wireless curtain motor
HDL-MWM70-RF.12
Exit the status
－－
Long press the button for 3s
/ no operation for 2minutes
Long press the button for 5s
/ no operation for 20minutes
Long press the button for 10s
/ no operation for 20minutes
Press the button 1 time/ no
operation for 4 minutes
2/ 7
Advertisement
